RESUMEN
[This corrects the article DOI: 10.1016/j.heliyon.2023.e15078.].
RESUMEN
This study investigated the phycoremediation abilities of Chlorella vulgaris (microalga) and Anabaena variabilis (cyanobacterium) for the detoxification of polluted river water. Lab-scale phycoremediation experiments were conducted for 20 days at 30 °C using the microalgal and cyanobacterial strains and water samples collected from the Dhaleswari river in Bangladesh. The physicochemical properties such as electrical conductivity (EC), total dissolved solids (TDS), biological oxygen demand (BOD), hardness ions, and heavy metals of the collected water samples indicated that the river water is highly polluted. The results of the phycoremediation experiments demonstrated that both microalgal and cyanobacterial species significantly reduced the pollutant load and heavy metal concentrations of the river water. The pH of the river water was significantly raised from 6.97 to 8.07 and 8.28 by C. vulgaris and A. variabilis, respectively. A. variabilis demonstrated higher efficacy than C. vulgaris in reducing the EC, TDS, and BOD of the polluted river water and was more effective at reducing the pollutant load of SO42- and Zn. In regard to hardness ions and heavy metal detoxification, C. vulgaris performed better at removing Ca2+, Mg2+, Cr, and Mn. These findings indicate that both microalgae and cyanobacteria have great potential to remove various pollutants, especially heavy metals, from the polluted river water as part of a low-cost, easily controllable, environmentally friendly remediation strategy. Nevertheless, the composition of polluted water should be assessed prior to the designing of microalgae- or cyanobacteria-based remediation technology, since the pollutant removal efficiency is found to be species dependent.
RESUMEN
Toxic element accumulation in the surrounding soils of the advanced industry- and agriculture-oriented areas may lead to severe environmental degradation and harmful impact on inhabitants. This work examined the concentration of some concerned toxic elements (Cr, Pb, Cd, Cu, As, and Ni) in the representative topsoil from 10 industrially contaminated sites in central Bangladesh (Narayanganj district) using an Inductively Coupled Plasma Mass Spectrometer concerning the probable ecological and human health risks. The mean concentrations (mg/kg) of the elements were found in the order of Ni (58.1 ± 11.8) > Pb (34.1 ± 14.3) > Cr (32.1 ± 6.77) > Cu (14.5 ± 3.30) > Cd (2.74 ± 1.08) > As (1.49 ± 0.43). The findings pointed out that diversified manmade events enhanced the intensities of elemental contamination through the studied sites. Source analysis showed that Cr, Pb, As, and Cd may originate from industrial wastewater and agricultural activities, whereas Cu and Ni came from natural sources. The geo-accumulation index level for Cd (1.70-3.39) was determined as grade 3 (moderately to strongly polluted), the enrichment factor score for Cd (13.9) fell in the very severe enhanced category (cluster 5), and the highest contamination factor value was found for Cd (15.7). The contamination degree values for all the tested elements signify a moderate to severe contamination grade; conversely, pollution load index levels depicted the nonexistence of elemental pollution. The assessment revealed serious Cd pollution in agricultural soils and moderate to significant potential ecological risk for the rest of the examined toxic elements. Furthermore, hazard index values exceeded the safe exposure levels, indicating that there was potential non-carcinogenic risk in the soils for children and adults. Ingestion exposure had much higher carcinogenic risk values than inhalation and cutaneous exposure, and children are exposed to considerable carcinogenic hazards. Therefore, it is suggested that the harmful practices that expose this farming soil to contaminants should be stopped immediately and effective environment-friendly techniques of waste management and effluent treatment should be employed in the study area.
